05-15-2007 05:49 PM - edited 03-05-2019 04:05 PM
I am tryig to install a T1 controller 1mft Wic in a 2811 router. I don't see the contoller to configure it. I do see it if I run sh diag but not in show config. What am I missing to register the card so can set it up for voice.
Thanks
05-15-2007 05:55 PM
If it is a T1/E1 card, you need to first configure "card type t1 0 0", depending on what slot you have the card in.
05-15-2007 05:59 PM
it is a daughter card in slot 0 but the router won't take card type as on option?
05-15-2007 06:08 PM
What is the part number of the card?
05-15-2007 06:13 PM
WIC Slot 0:
T1E1 (1 port) WAN daughter card
Hardware Revision : 0.0
Top Assy. Part Number : 800-22628-05
Board Revision : A0
Deviation Number : 0
Fab Version : 04
PCB Serial Number : FOC10520QNU
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Product (FRU) Number : VWIC2-1MFT-T1/E1
Version Identifier : V01
EEPROM format version 4
05-15-2007 06:16 PM
So that card will do either T1 or E1, in global config, you should be able to use the card type command.
05-15-2007 06:17 PM
TGO-MKE-Honeycreek-Router#
TGO-MKE-Honeycreek-Router#config t
Enter configuration commands, one per line. End with CNTL/Z.
TGO-MKE-Honeycreek-R(config)#card
TGO-MKE-Honeycreek-R(config)#card ?
% Unrecognized command
TGO-MKE-Honeycreek-R(config)#card
05-15-2007 06:21 PM
Hmm. What version of IOS?
05-15-2007 06:24 PM
Cisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.3(8)T8, RELEASE SOFTWARE (fc1)
I thought maybe I was loosing my mind. Very odd nothing seems to be working
05-15-2007 06:25 PM
Well, I can't vouch for your mind ;), but it sure seems like it should be working. Maybe try a different slot, or a reload?
05-15-2007 06:28 PM
maybe a reload of the IOS? I do have 2 cards and installed the second into another slot to see if that would make a difference but no luck. Strange it shows in sh diag but can't configure it?
05-15-2007 06:30 PM
Or maybe go up to 12.4, if you don't mind running that.
05-15-2007 06:32 PM
I will try that tomorrow and see what happens
thanks for the help
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: