vlans using ospf

carl_townshend · ‎05-16-2007

If I have 3 routers with vlans configured, do i just have to include the vlan ip address into the routing statement, and make sure the other router has at least 1 ip address in the same vlan, then this should recieve info about other vlans in the switch

vladrac-ccna · ‎05-16-2007

hello Carl,

how are you doing?

may I ask you something. Ive noticed that you've been posting here for a long time.

Are you studying network ?

Anyway...you need to be more specific when asking this kind of question.

There're many issues with OSPF.

Usually if you have 3 routes connected via some ethernet interfaces. its just a matter of setting the networks on area 0 and you're good to go.

But again, its a bit hard to understand your question.

Vlad