2800 router connected to a 2950 or 2960 switch

Unanswered Question
May 16th, 2007

What I have been seeing is a site will loose power and then after the equipment is back up the E/N switch port will be blowing errors. The only way I have been able to clear this is by resetting the switch. Any suggestions.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Wed, 05/16/2007 - 19:04

Hi Simmons

When the power goes off is your Switch still on and working ?

Also not sure about E/N switch port as you have mentioned over here..

What about the other end of the switch port ?

Did you try monitoring the other end too ?

regds

Actions

This Discussion