05-17-2007 03:30 AM - edited 03-05-2019 04:07 PM
Hi,
Can somebody tell me what command should I run in order to find the BW utilization on my router's interface?
Thanks,
Haitham
05-17-2007 03:44 AM
Hi
In "sh int" you will see txload and rxload. these are in terms of 255 (not 100) These are very fast tools to check the lnik utilization.
Regards
JD
05-17-2007 03:45 AM
hi
you can check with show interface serial x/x just replace the serial keyword with other interface type if you are trying to monitor any other interface type.
You can check out the input/output packet utilisation which is of 5 Minute stats which you can change back to 30 Second period using load-interval 30 under the interface mode.
the other way of doing out this is by enabling snmp to send the traps back to your NMS server for which you can make use of PRTG or MRTG application...
regds
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: