05-17-2007 03:48 AM - edited 03-05-2019 04:07 PM
Hi,
Please i forget my router 1700 series router enable password.i start it and press "Control + B", but i don't get it.Can you help me on this please.
05-17-2007 03:49 AM
Hi
Its Ctrl+Break. Break key ia at extreme upper right at ur kbd.
Regards
JD
05-17-2007 04:04 AM
Hi,
Please after the control break,what do i have to do next
05-17-2007 04:16 AM
Hi
(1)You can use command
>config-register 0x2142
>in
This will reboot the router ingnoring the NVRAM
(2)
Router>en
(3)
Router#copy sta run
YourRouterHostName#config t
YourRouterHostName(config)#ena sec YourPassword
YourRouterHostName(config)#config 0x2102
YourRouterHostName#wr
pls do not change any step's order, you may end up losing ur config.
It will be better at step 3 to copy your start-up config(You must be knowing how to copy the config from hyperterminal to notepad)
Pls rate helpfull posts.
Regards
JD
05-17-2007 04:47 AM
Thanks, it is very helpful,but how can i copy from hyperteminal to notepad
05-17-2007 07:49 AM
Hi
You can just copy the output just as u copy from a DOS window.
or
(1)click on Start-->Capture text
(2)Notedown the file path
(3)Click ok
(4)give " sh sta"
(5)move to next page using
(6)perform step 5 till u end the config.Just like u are viewing the config.
(7)open the said file using notepad. You will see the config there.
Hope that will help. In case of any diff. shoot back.
pls keep rating :)
regards
JD
05-17-2007 03:50 AM
Hi Friend,
I hope this should help you
HTH
Ankur
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide