05-17-2007 03:48 AM - edited 03-05-2019 04:07 PM
Hi,
Please i forget my router 1700 series router enable password.i start it and press "Control + B", but i don't get it.Can you help me on this please.
05-17-2007 03:49 AM
Hi
Its Ctrl+Break. Break key ia at extreme upper right at ur kbd.
Regards
JD
05-17-2007 04:04 AM
Hi,
Please after the control break,what do i have to do next
05-17-2007 04:16 AM
Hi
(1)You can use command
>config-register 0x2142
>in
This will reboot the router ingnoring the NVRAM
(2)
Router>en
(3)
Router#copy sta run
YourRouterHostName#config t
YourRouterHostName(config)#ena sec YourPassword
YourRouterHostName(config)#config 0x2102
YourRouterHostName#wr
pls do not change any step's order, you may end up losing ur config.
It will be better at step 3 to copy your start-up config(You must be knowing how to copy the config from hyperterminal to notepad)
Pls rate helpfull posts.
Regards
JD
05-17-2007 04:47 AM
Thanks, it is very helpful,but how can i copy from hyperteminal to notepad
05-17-2007 07:49 AM
Hi
You can just copy the output just as u copy from a DOS window.
or
(1)click on Start-->Capture text
(2)Notedown the file path
(3)Click ok
(4)give " sh sta"
(5)move to next page using
(6)perform step 5 till u end the config.Just like u are viewing the config.
(7)open the said file using notepad. You will see the config there.
Hope that will help. In case of any diff. shoot back.
pls keep rating :)
regards
JD
05-17-2007 03:50 AM
Hi Friend,
I hope this should help you
HTH
Ankur
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: