Wireless bridges (Cisco 1310)

Unanswered Question
May 17th, 2007

I am looking to connect a remote location to our main LAN via a wireless bridge (Cisco 1310). I was going to use a WAP (Cisco 1100) at the facility end but someone told me that a bridge can only communicate with another bridge.

Is this true?

If this is the case, then I would have to use (2) Cisco 1310's correct?

thx

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Thu, 05/17/2007 - 07:35

Yes for true bridging you will need to use two bridges. You can send further queries to the wireless forum too.

james0816 Thu, 05/17/2007 - 08:40

What do you mean by "true" bridging?

The remote location will only be sending data to a machine on the LAN. There will not be any communication back to the remote segment.

Actions

This Discussion