no syslog message when Cat4500 module removed

croue · ‎05-18-2007

I have a Cisco Catalyst 4507R with two Sup-Engine V-10GE.

When I remove from the chassis the active SUP-Engine, the switchover works fine, but there is no syslog message on the LMS syslog.

When I re-insert the module in the chassis, syslog messages appeared well on LMS syslog (module inserted).

The IOS is: 12.2(31)SGA1

the config is:

logging 172.30.7.240

!

snmp-server community fread RO

snmp-server community fwrite RW

snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart

snmp-server host 172.30.7.240 f1matread

ankbhasi · ‎05-18-2007

Hi Friend,

Can you configure these 2 commands and update the status

snmp-server enable traps entity

snmp-server enable traps fru-ctrl

Regards,

Ankur

croue · ‎05-19-2007

The problem is not resolved.

The logs that appear on the Cat4507R console are:

May 18 06:58:22.902: %C4K_IOSMODPORTMAN-6-MODULEOFFLINE: Module 2 is offline

May 18 06:58:23.906: %C4K_IOSMODPORTMAN-6-MODULEREMOVED: Module 2 is removed

But thez don't appear on the LMS Syslog.