No syslog message when 4507R SUP V-10GE is removed

Unanswered Question
May 18th, 2007

I have a Cisco Catalyst 4507R with two Sup-Engine V-10GE.

When I remove from the chassis the active SUP-Engine, the switchover works fine, but there is no syslog message on the LMS syslog.

When I re-insert the module in the chassis, syslog messages appeared well on LMS syslog (module inserted).

The IOS is: 12.2(31)SGA1

the config is:

logging 172.30.7.240

!

snmp-server community fread RO

snmp-server community fwrite RW

snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart

snmp-server host 172.30.7.240 f1matread

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Fri, 05/18/2007 - 07:39

What messages do you have in your logging buffer on the switch?

Actions

This Discussion