05-18-2007 06:00 AM - edited 07-03-2021 02:05 PM
please can you tell me how can i configure controller to support wireless ip phone and why phone not detected the SSID or any signal from the AP
05-18-2007 01:06 PM
Which phone are you using?
For 7920/7921, can refer to the 7921 admin guide @ http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/
Also deployment guide @ http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/7921dply.pdf.
Also WLAN SRND @ http://www.cisco.com/univercd/cc/td/doc/solution/emblty30.pdf.
06-29-2007 04:54 AM
Hi,
I got the same problem. I was trying to use the Lynksis WIP330 IP phone on a AP1240AG. The AP diffuse two ssid, an open and a secure. The Secure uses a radius server (EAP - WAP2).
The ip phone sees only the Open SSID :s. I don't understand why because a Siemens Ip Phone can see the Secure ssid :'(
Could someone give help ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: