VPN Setup on Pix 515e

Unanswered Question
May 18th, 2007
User Badges:

Hello - I have a pix 515 that I am trying to enable VPN for. I went through the VPN wizard, choosing the options

Remote access

outside interface

PPTP

MSCHAP

Local VPDN - I set up a user

my Pool is 192.168.1.0-192.168.1.100 (inside network is 192.168.0.X)

I am pushing the dns server IP for the pix to the clients

I am leaving address translation exemption blank.


I can connect from outside the network, I just can't see the inside network.


What am I missing here?


I can post the running configuration if that would help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
acomiskey Fri, 05/18/2007 - 08:18
User Badges:
  • Green, 3000 points or more

isakmp nat-traversal


Just a guess with limited information, if not post your config.

njamabraasch Fri, 05/18/2007 - 08:25
User Badges:

Thanks for the response!


Is that a line in my config that I need to add? so far I've done some limited manual config changes, but I mostly work through the PDM. Can you elaborate?

acomiskey Fri, 05/18/2007 - 08:31
User Badges:
  • Green, 3000 points or more

Yes it is. Not sure where it is in PDM, somewhere in the vpn options, but is probably a check box that says something about allowing inbound ipsec sessions to bypass interface access lists. Is this pix 6 or version 7? Oops, skimmed through too fast, you're doing pptp, don't think that will work. Post a clean config.

Actions

This Discussion