05-18-2007 11:44 AM - edited 03-11-2019 03:16 AM
i have cisco pix515E with three interfaces tow are built-in and one is external , i'm configure my pix in the simple set way just inside(e1) 100 and outside(e0) 0 , the problem was i can not ping or connect to any of my inside or outside interfaces where i can ping and connecte the dmz(e2) external interface ,when i plug the cable it seems to be connected and evrey thing is good but both built-in interfaces can not act with me i'm romve all configuration and write it agine and fromat the entier flash and load the new image i tried 6.2,6.3 and 7.0 and i still have the sam problem ,i thing it is a hardware problem, pleas don't aske me to check my configuration i'm sure it all ok it a simple configuration and i'm (CCNP and CCSP cisco certifited) , it is realy strange problem , so can any one help pleas
05-18-2007 11:55 AM
If you do a sh ver do you see all interfaces?
If so and you're not getting any errors on boot then I would have to ask that you post your config. Sorry, but I don't see being able to help without seeing it.
Paul
05-18-2007 12:09 PM
05-18-2007 12:12 PM
sir,
by the way when i apply the command so ver i can see all the interfaces which interface e0, e1 and e2.
thx
05-18-2007 12:26 PM
You haven't defined any hosts which are allowed to connect to the firewall.
ssh 192.168.x.y 255.255.255.255 inside
or
ssh 10.x.y.z 255.255.255.255 outside
or something along those lines.
05-18-2007 12:34 PM
friend i don't have to define any of these commands bec i just wana to ping the pix frist and i have define it in icmp permit any inside ....and so , just for your kwolege you have to set ssh or telnet just if i have to connecet to your firewall by pdm asdm or to telnet to your firewall ,it is don't have any related to my problem whatever thanx friend
05-21-2007 06:28 AM
Hi Emad-
When you try these pings, where is your pc connected? Also, if you do a sh int, do all 3 interfaces show up/up?
Sorry for the delayed response - I've been out of town.
Regards,
Paul
05-22-2007 05:54 AM
Hi friend :
My laptop in connected to my pix by crossover cable , the strange thing is when i connect the laptop i see the network in my laptop is connected and the sh int e0 showing me up/up
but there is no connectivity in fact at all
i thing it is a hardware problem friend ,so i'll trun back this pix to the vendor
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide