ASA 5510 Failover Issue

Unanswered Question
May 18th, 2007

Hey all,

I'm trying to configure failover on a pair of ASA 5510 firewalls. Both are running Security Plus Licenses. How I have know PIX and ASA failover to work is that each interface on both firewalls have addresses on the same subnet and the addresses that is functional is that of the primary. When I issue a 'show failover' on both ASA in my current scenario the Standby address for all interfaces appear as 0.0.0.0. The failover interface that I am using is Ethernet0/3. See attached output which as the following obtained from a console session:

1. show version

2. show fail

3. show run fail

4. show fail interface

Any thoughts??

-lloyd

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ebreniz Thu, 05/24/2007 - 05:27

Use the show failover state command to verify the state.

Actions

This Discussion