Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
318
Views
4
Helpful
1
Replies

multilink connection

bikash_bd
Level 1
Level 1

‎05-19-2007 12:35 AM - edited ‎03-03-2019 05:02 PM

Dear friends,

I have a pair of MWR-1941-DC router which has built in Y cable configuration. It has two E1. Now I want to multilink these two E1 so that they act as a single. So will you provide methe multilink configuration?

Bikash

Labels:
0 Helpful
1 Reply 1

royalblues
Level 10
Level 10

‎05-19-2007 02:12 AM

Create a multilink interface

interface multilink 1

ip address x.x.x.x y.y.y.y

ppp multilink

ppp multilink group 1

Assign the individual serial interfaces to the multilink group

Controller e1 1/0

channel-group 0 timeslots 1-31

controller e1 1/1

channel-group 0 timeslots 1-31

interface serial 1/0:0

no ip address

encap ppp

ppp multilink

ppp multilink group 1

interface serial 1/1:0

no ip address

encap ppp

ppp multilink

ppp multilink group 1

http://www.cisco.com/en/US/products/hw/routers/ps4062/products_configuration_guide_chapter09186a008076fdce.html#wp1055832

HTH, rate if it does

Narayan

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card