Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
317
Views
4
Helpful
1
Replies

multilink connection

bikash_bd
Level 1
Level 1

‎05-19-2007 12:35 AM - edited ‎03-03-2019 05:02 PM

Dear friends,

I have a pair of MWR-1941-DC router which has built in Y cable configuration. It has two E1. Now I want to multilink these two E1 so that they act as a single. So will you provide methe multilink configuration?

Bikash

Labels:
0 Helpful
1 Reply 1

royalblues
Level 10
Level 10

‎05-19-2007 02:12 AM

Create a multilink interface

interface multilink 1

ip address x.x.x.x y.y.y.y

ppp multilink

ppp multilink group 1

Assign the individual serial interfaces to the multilink group

Controller e1 1/0

channel-group 0 timeslots 1-31

controller e1 1/1

channel-group 0 timeslots 1-31

interface serial 1/0:0

no ip address

encap ppp

ppp multilink

ppp multilink group 1

interface serial 1/1:0

no ip address

encap ppp

ppp multilink

ppp multilink group 1

http://www.cisco.com/en/US/products/hw/routers/ps4062/products_configuration_guide_chapter09186a008076fdce.html#wp1055832

HTH, rate if it does

Narayan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card