05-19-2007 04:19 AM - edited 03-11-2019 03:17 AM
In order to do failover between 2 PIX 515 firewall is there any specific requirement that the hardware configuration on both the PIX to be the same, i.e the no.of ethernet ports , RAM etc. Say if I have 3 FE ports on one firewall and the other firewall has 4 ports , in that case will the failover work.
05-19-2007 06:37 AM
hello,
read this link
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/config/failover.htm
in short as far as the document says YES both should be the same, in which having one addtional requirement of unrestricted license, but i am not sure about ethernet ports but partically speaking i think YES it would be important also to have same interfaces on both. but i am not positive.
HTH, please rate it.
05-19-2007 09:26 AM
Even i am not sure about the interfaces but thinking logically when you write the configuration from Active to standby the configuration is replicated on the standby so ideally its best to have both the PIX absolutely same.
-Hoogen
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide