setting up a dsl as failover on 2600 series router

Unanswered Question
May 19th, 2007
User Badges:

I need to setup a failover line. the primary line is a T1 which is connected to serial interface. the secondary line is install to the FE0/1 of a 2600 series router. when i configure the nat pool IPOOL i get a error message saying that dynamic maping in use i need to have a sample config to complete this

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
foxbatreco Sat, 05/19/2007 - 21:38
User Badges:
  • Bronze, 100 points or more

Hii,

the msg comes up in there at nat sessions moving on...so u need to clear the ip translations and try executing the command.. if still msg crops.then u might hv to shut the local inside nat interface for a while ..

pls do rate the post.

Actions

This Discussion