CCM 5.1 and h323 gateway

Unanswered Question

Hello all!


I need your help! I try to connect CCM and my h323 provider.


[ISP]---[2811]---[CCM]


Call came from provider to my 2811 and should be translate to CCM, but - I can get call, but after 5 sec. connectons droped, no voice on both end. Why? How can I debug what is going on?


My second problem - no call route outside my network. I add h323 gateway, create route group/route list/route pattern, CCM trying to place call, but after 30-40 sec. i can't place a call. How can i see logs/debugs about WTF ig going on CCM? I can debug and trace everything on 2811, but how can i debug a call on CCM?


My 2811 config is:


!

!

voice service voip

allow-connections h323 to h323

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none

h323

!

!

!

interface FastEthernet0/1

description ==C2811_CONNECT==

ip address 192.168.5.2 255.255.255.252

duplex auto

speed auto

h323-gateway voip interface

h323-gateway voip h323-id c2811

h323-gateway voip bind srcaddr 192.168.5.2

!

!

dial-peer voice 5 voip

destination-pattern 1010

voice-class codec 1

session target ipv4:192.168.5.1

dtmf-relay h245-alphanumeric

no vad

!

!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Sun, 05/20/2007 - 15:36
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

How si the GW connected to PSTN, what circuit do you have? PRI, CAS, FXO, SIP????


Chris

Actions

This Discussion