MSFC interfaces

Unanswered Question
May 21st, 2007

I have never used a MSFC but I can see it has just as many options as a router would have but the only question I have is how do you configure the interfaces? I am going to be doing some inter-vlan routing and I dont get how I specify the interfaces and subinterfaces I want to route between. Any help I would be greatful. Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Jon Marshall Mon, 05/21/2007 - 06:35


You configure Switched Virtual interfaces for inter-vlan routing ie if you have a layer 2 vlan 20

msfc(config)# int vlan 20

msfc(config-if)# ip address x.x.x.x "subnet mask"

msfc(config-if)# no shut

For each vlan you want to route for you need a L3 vlan interface as above.




This Discussion