DSP req help needed

Unanswered Question
May 21st, 2007

hi all

i have the following scenario:

single site ip telephony with 2 7825 ibm MCS's Pub & Sub

users are 160 users

there r 2 redundant 2821 gateways each one has the following:


2 ports NM-HDV2-2E1

vic-4fxo

PVDM2-32 included

C2800NM-SPSERVICESK9-M Version 12.4(3g), RELEASE SOFTWARE (fc2)


ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)


System image file is "flash:c2800nm-spservicesk9-mz.124-3g.bin"


there are 2 E1's PRI, one E1 on each gateway


my question is on DSPs required for voice termination and conference,

is PVDM2-32 on each gateway enough??


i ask this because when i added the command:

Pri-group timeslots 1-31 service mgcp

it gives me an error like that no dsp enough for 30 channels, it is only enough for 28 channels?!


now, when i added a phone and configured the gateway,and made a call from pstn to this ip phone it rings but i did not hear ringback tone, and when ip phone went offhook there is no voice heared at all!!


does any one have an idea how to solve this problem, i think the all story is about DSP's?!!


attached is the output of sh dspfarm all



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
user-cisco Mon, 05/21/2007 - 09:20

thanks Chris

if so, then i have 32 channels to terminate 32 g711 calls, but why is the output for the sh dspfarm all

is


Total number of DSPFARM DSP channel(s) 0


and when calling from pstn there is no ring back tone and there is no voice heared at all neither from called ip phone side nor from caller side??

Actions

This Discussion