05-21-2007 11:19 AM - edited 03-14-2019 09:37 PM
hi all
if i have PVDM2-xx on 28xx series gateway's motherboard, and a network module (NM-HDV2-1E1) but this module does not have any PVDM2 on it
how can i let the network module take DSP resourses from motherboard DSPs this is cause it needs dsp resources to make voice termination to pstn?
please help
05-22-2007 07:47 AM
That is called DSP sharing.
To enable DSP sharing, use dspfarm commando in the voice-card configuration.
This example was taken from Voice GWs and GKs book.
2811 ISR with a PVDM2-16 in the mainboard and NM-HDV2 in slot 1. With this configuration, the DSPs on the main board are exported, allowing them to be allocated to voice calls arriving on a T1 or E1 port in the NM-HDV2. The DSPs in the NM-HDV2 are not being exported in this ex.
Router#conf t
Router(config)#network-clock-participate wic 2
Router(config)#network-clock-participate slot 1
Router(config)#voice-card 0
Router(config-voicecard)#dspfarm
Router(config-voicecard)#end
The DSPs on the main board of an ISR are configured under voice-card 0
05-22-2007 12:41 PM
I tried dspfarm command under voice-card 0 and made a call from pstn to ip phone, it rings but calling party did not hear ring back and when call was answered there was no audio!!
please help solving this issue
05-22-2007 02:55 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: