WGB with AP1310 and LAP with WLC in 4.1

Unanswered Question
May 21st, 2007

I make a WGB with a autonomous AP1310 and an LAP manage by a WLC2006 in 4.1 version.

The bridge is up and working, but it's very strange:

- The bridge is up and i can always ping the IP of the BRI interface of the 1310.

- When the bridge go up, i see the IP of computer behind the 1310 in a Wireless client list of the controler, but i can ping it only 25% of time.

- If i wait a long time, the MAC/IP are leaving the Wireless client list of the controler and i can ping the computeur. At this time, if i do a "debug arp enable" on the controler i didn't see ARP response from the controler for computeur bihind the bridge.

Does anyone have the same problem ? Does anyone do WBG with controler in 4.1 ? Any issues ?

Thanx for your help.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode