Customize CAD display

wenqianyu · ‎05-21-2007

I am using IPCCX 4.0(5). In the CAD display, there are two Lanes, one called Enterprise Data Lane (left). The one on the right (not sure what name it is) has a few lines displayed when a call come to this agent phone. The information on this area is not really interested by the Agents. Is there a way to remove some of them (such as CTI port)? I tried from Cisco Desktop Administrator and could not find a place to change that.

Any idea?

Thanks a lot.

carenas123 · ‎05-25-2007

You cannot remove the CTI port and CTI route point from displaying in the enterprise CAD desktop.

Sandy Lee · ‎11-09-2007

Hi,

Did you found something out? because I'm in the same situation here. If you found a way to do that, I would appreciate to know how.

Thanks and regards.