Kingston Communications in UK

Unanswered Question
May 22nd, 2007
User Badges:

Has any body got a samle config that i can use on a cisco 877 for connecting to there ADSL service. i cant seem to get connected with the useually settings in the UK. i am interest in the ATM0 settings and Dialer1 setup pvc etc.

many thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
bjornarsb Tue, 05/22/2007 - 05:26
User Badges:
  • Bronze, 100 points or more


Try this: (Kingston Comm)

Interface Type - PPPoA (RFC 2364)


VCI 50

Authentication Mode CHAP

Modulation Type G.DMT

Encapsulation Mode LLC (aal5snap)


interface Vlan1

ip address

ip nat inside

ip virtual-reassembly (default)


interface ATM0

no ip address

ip nat outside

ip virtual-reassembly

no atm ilmi-keepalive

pvc 1/50

encapsulation aal5snap ppp dialer

dialer pool-member 1


dsl operating-mode auto


interface Dialer0

ip address negotiated

ip mtu 1492

encapsulation ppp

dialer pool 1

dialer-group 1

ppp authentication chap


ip classless (default)


ip nat pool pool1 netmask

ip nat inside source list 1 interface Dialer0 overload


access-list 1 permit

dialer-list 1 protocol ip permit

ip route dialer 0




bjornarsb Tue, 05/22/2007 - 05:35
User Badges:
  • Bronze, 100 points or more


OK, please rate if it works :)



Aaron Harrison Sat, 07/07/2007 - 00:25
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015

Hi All!

I'm also having some grief with an 877 (in the UK - not Kingston but you may have similar issues). If you aren't getting the ATM interface up at all, try going to this URL:

Download the 3.0.10 ADSL firmware. Copy it to flash, and rename to this name exactly:


This got mine trained up fine - prior to this it appeared to be dead...



Please rate helpful posts...


This Discussion