ASA 5505 - snmp not working

pslovinsky · ‎05-22-2007

Hi,

I've Cisco devices ASA 5505 ver 7.2 software. The issue

involves SNMP, specifically the monitoring of traffic counters to

create traffic graphs (MRTG). I can poll the device and I

get a response. I can list interface descriptions/ip address etc.

Everything else appears to be working fine. When I monitor the

inbound and outbound traffic I get responses back via SNMP, but the

values show same on all interfaces (outside, inside, dmz).

I've never seen this before and I'm wondering if this is bug.

Any ideas?

Thanks

PATO

pslovinsky · ‎05-22-2007

picture

acomiskey · ‎05-22-2007

Is there a .cfg config file for prtg like there is for mrtg? Could you post it?

pslovinsky · ‎05-22-2007

mrtg.cfg

http://www.backbone.sk/snmp/

tllewis · ‎05-31-2007

Pato, I'm running into the same issue w/ MRTG and BMC Dashboard. Have you received any fix responses?

pslovinsky · ‎05-31-2007

No, I dont have any receive about fix. :-(

fanheuser · ‎06-08-2007

Hi,

I've seen that, too -- my guess is that this indeed is a bug: the ASA 5505 internally has switch ports only, which are kept separate by using VLANs. Apparently, the 5505 SNMP agent is smart enough to show the VLAN interface names and addresses, but shows the traffic data of the main interface only (of which there is only one).

On the other hand, the ADSM somehow can display correct traffic statistics for ASA 5505, but I do not know how it obtains the data.

Frederik

pslovinsky · ‎06-08-2007

Hi Frederik,

did you open the TAC case on Cisco site about this problem with ASA 5505?

PATO

pslovinsky · ‎06-08-2007

Hi Frederik,

did you open the TAC case on Cisco site about this problem with ASA 5505?

PATO

pslovinsky · ‎07-09-2007

Hi all,

problem is done (bug No:CSCsi15805)

Thank you for your assistent.

PATO