Phone load for 7931G help

Unanswered Question
May 22nd, 2007
User Badges:

Can someone help me with the correct syntax for the 7931G phone load in CCME

I can't get the phone to select the correct phone load. Right now is selecting term31.default, but I want to specify the correct phone load. I downloaded the 7931 file from Cisco's website but the phone does no take it.

Any ideas

Here is my syntax



File from Cisco CME-7931_8-1-1SR2RN_SCCP.tar extracted to flash

tftp-server flash:apps31.8-1-0-89.sbn

tftp-server flash:cnu31.8-1-0-89.sbn

tftp-server flash:cnu31.8-1-0-89.sbn

tftp-server flash:cvm31sccp.8-1-0-90.sbn

tftp-server flash:dsp31.8-1-0-89.sbn

tftp-server flash:jar31sccp.8-1-0-90.sbn

tftp-server flash:SCCP31.8-1-1SR2S.loads

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
aramos17428 Tue, 05/22/2007 - 21:15
User Badges:

The configuration is still being imported by QCT so all I have connected at this point is 3 phones ( 1 7941 and 2 7931G. I'm running CME 4.1 which supports the 7931G and the phones are coming up and registering. However, i would like to select the correct firmware for the phone, term.31 as firmware seems to me like default phone load and not the correct one for 7931G SCCP. With the 7940 and 7960 I know how to do it but with the 7931G the file extension are different and do not know which is the correct one.



John Clark Tue, 05/22/2007 - 21:44
User Badges:

try adding the following

conf t


load 7931 SCCP31.8-1-1SR2S

create cnf

then reset the phone.


This Discussion