05-22-2007 02:08 PM - edited 03-05-2019 04:13 PM
All, Ive never seen a 2948 CatOS switch before. Im wanting to create a trunk port to another Cisco switch. How would I go about doing that on the 2948 CatOS switch? Thanks.
05-22-2007 02:15 PM
Hi,
It should be something like this:
set trunk 0/1 on
HTH, please do rate all helpful replies,
Mohammed Mahmoud.
05-22-2007 02:26 PM
Hi,
It should be something like this:
set trunk 0/1 on
HTH, please do rate all helpful replies,
Mohammed Mahmoud.
05-22-2007 04:04 PM
You can use this too "set trunk desirable dot1q" . Vtp domain names must match and the switch on the far end must be set to desirable or auto for trunking . If the far end is IOS " " switchport mode dynamic desirable "
05-22-2007 06:13 PM
thanks guys.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide