Problems with VWIC-2MFT-E1DI

Unanswered Question
May 23rd, 2007


we have a problem with several Cisco 3825 and a VWIC-2MFT-E1DI module installed.When yoe connect 2 E1 links (channeled) on the interface there is an increasing number of CRC errors and also a loss of pings.

After installing 2 moduls and putting the lines on each of the 2 interfaces everything works fine.

On some routers it works fine with one interface.

Any ideas what could cause this problem?

Also I heard about a "bad" range of serial numbers of the chassis!?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
dsweeny Tue, 05/29/2007 - 06:53

I believe you need to push up the bandwidth and redifine the time slots in this case

Paolo Bevilacqua Tue, 05/29/2007 - 07:01

Can be a clocking problem.

Please send all the details of the connections (what is connected to what) and the router configuration, plus output of "show interface" and "show network-clock".


This Discussion