Problem integrating service Providers Voice link (E1) with AS5300 Gateway

Unanswered Question
May 23rd, 2007
User Badges:


Scenerio:

I have a cisco Callmanager integrating with an AS5300 PSTN Gateway on my network, am currently trying to integrate an E1 (direct Connect) for voice, from a service provider so as to route outgoing calls from my network through them.I have a challenge of been able to display my caller id on the receivers end, instead of the pilot number given to me by th provider.


e.g If I place a call from any extension on my network say 1652, i expect to see

0808926(1652) on the receivers end, but instead the pilot number from the service provider 0808926(0000)is displayed on the receivers set.


How can i resolve this issue? the service provider uses an Ericsson AXE 810


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
teodorgeorgiev Mon, 05/28/2007 - 00:33
User Badges:
  • Bronze, 100 points or more


Run a "debug isdn q931" on the Cisco (apply it on the outgoing interface) and post it here.



paolo bevilacqua Mon, 05/28/2007 - 14:20
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You need to use route mask on the CCM, please report in "ip telephony" to receive a more detailed answer, or search the forum.

Actions

This Discussion