05-23-2007 11:05 PM - edited 03-05-2019 04:16 PM
Hi all
I wrongly assigned "native vlan x to one f0/x port" now I want remove that how what is the proper commands shall I give.
plz. give early reply.
thanks in advance
05-23-2007 11:13 PM
If the port is a trunk port then use the following conmmand:
int fa 0/x
no switchport trunk native vlan x
This will revert the native vlan as Vlan1 on the traunk port.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12235se/cr1/cli3.htm#wp1948736
HTH,Please rate if it does.
-amit singh
05-23-2007 11:15 PM
hi amit
how we can find it's trunk port or not
thanks for early reply.
naidu
05-23-2007 11:21 PM
Naidu,
Two ways:
1. Check the interface config " show run int fa 0/x" and check if command " switchport mode trunk " is present.
2.Use the command " show interface fa0/x switchport " to check the operational mode of the switchport.
HTH,Please rate if it does.
-amit singh
05-23-2007 11:23 PM
Hi Naidu,
Issue a command "sh interface
Switch#sh int gig1/0/23 switchport
Name: Gi1/0/23
Switchport: Enabled
Administrative Mode: trunk
Operational Mode: trunk
Alternatively you can issue a command
"sh interfaces trunk" and it will list all interface which are configured as trunk ports.
HTH
Ankur
*Pls rate all helpfull post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: