H.323 gateway incomming calls on FXO ports

Unanswered Question

Hi,

I have an H.323 gateway with CM 4.1. Calls are going out and comming in fine. However, I changed the plar command on the voice port to plar to a diffrent extension. I updated the corresponding dial-peer, but it is not working. Calls can still come in on other ports and go out, but they are just not working on the port I changed the plar for.

Is there something I need to reset for this to work. I verified that the CSS and partition is not the issue. I can call the same DN from a phone in the same partition and CSS. I tried reseting the CTI route point, but that did not work. I verified that the dial-peer is being hit, but I just get a busy signal immediatly once the call hits the gateway.

voice-port 0/1/0

supervisory disconnect dualtone mid-call

echo-cancel coverage 32

timing hookflash-out 500

connection plar 1751

description *** 377-6965 ***

caller-id enable

dial-peer voice 20 voip

preference 1

destination-pattern 1751

session target ipv4:10.150.152.6

dtmf-relay h245-alphanumeric

no vad

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Thu, 05/31/2007 - 07:07

The connection plar command needs to be configured on all of the voice-ports.Change the configuration to slow start so that it will work.

Actions

This Discussion