Isolate VLANs (1 for public, 1 for Private) - using WAP

Unanswered Question
May 25th, 2007

Need the following objectives:

Need 1 WAP Cisco 1130 to have 2 SSID's and each one it's own separate VLAN.

- Vlan 18 is going to for employess

- Vlan 19 is going to be "public" it will only have access to Internet

I have 1 vlan for internet which is Vlan 154

I have Vlan 100 is for the servers

- Vlan 18 should comunicate with both of them.

- Vlan 19 should only communicate with the internet Vlan, 154 but should also get a DHCP address from the server wich is 192.168.100.200

I have a Cisco 3560 Switch.

Help! How to isolate the VLan?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
manojr2005 Sun, 05/27/2007 - 03:25

is you 3560 a layer 3 syitch ? if yes then for the guest Vlan provide the ip helper address 192.168.100.200, create a ACL deny any any , then create acl Permit any host 192.168.100.200, this is to communicate with this server to get the DHCP. asign this Access group to the vlan 100 as in bound.

Actions

This Discussion