FWSM and Wireless Voice

Unanswered Question


How do I setup the FWSM so that wireless phone traffic will pass through to CM and other IP phones?

My setup is:

? Running a transparent context.

? WLC ssid tied to outside vlan.

? CM and other phones on inside.

? Outside set to 0

? Inside set to 100.

The wireless phone will work if I allow all IP traffic. However, if I want to actually control traffic through the FWSM, what inspect statements should I turn on? I know inspect skinny needs to be on, but does the ACL need to match the inspect statements (i.e. have an ACL to allow port 2000? Also, what about RTP, does the inspect skinny open ?pin holes? for the RTP streams? Do I also have an ACL for the RTP traffic?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion