SHOW CONTROLLERS COMMAND

Answered Question
May 26th, 2007
User Badges:

Hello,

When I run a show controllers command I get the following....


HD unit 0, idb = 0x29A82C, driver structure at 0x2A1DF0

buffer size 1524 HD unit 0, V.35 DCE cable, clockrate 64000


AND



HD unit 1, idb = 0x2A7680, driver structure at 0x2AEC40

buffer size 1524 HD unit 1, V.35 DTE cable


Of course much is ommited. I only want the info of DTE or DCE calbleing.

Is the HD 0 the serial 0 and HD 1 the serial 1?

If not what are the HD's?

Is there a better command to find DTE or DCE?


Correct Answer by paolo bevilacqua about 9 years 12 months ago

This is the only command to know what type of cable is attached, and yes 0 and 1 are the serial ports.


Hope this helps, please rate post if it does!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
paolo bevilacqua Sat, 05/26/2007 - 15:33
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

This is the only command to know what type of cable is attached, and yes 0 and 1 are the serial ports.


Hope this helps, please rate post if it does!

Actions

This Discussion