CM User Defined Group mempership not stable

Unanswered Question
May 29th, 2007
User Badges:

I have LMS 2.6 with CM 4.0.6,I create 5 user defined group,I am facing unstability problems, sometimes I go to CM topology I didn't found any device in this groups, I return back to CM group admin,then I edit the group I found the devices then I click finish then everything work fine.

The last problem I face it was now the user defined group has the all discovered devices not only the memper devices.

Any advice

Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Tue, 05/29/2007 - 10:06
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Debugging grouping problems can be tricky since it is not very easy to enable debugging. However, you can check the CampusOGSServer.log when you are experiencing a problem with the membership computation to see if there are any associated errors. If not, it may be best to open a TAC service request so that they can guide you through enabling and disabling OGS debugging.

Actions

This Discussion