05-29-2007 09:42 AM
I have LMS 2.6 with CM 4.0.6,I create 5 user defined group,I am facing unstability problems, sometimes I go to CM topology I didn't found any device in this groups, I return back to CM group admin,then I edit the group I found the devices then I click finish then everything work fine.
The last problem I face it was now the user defined group has the all discovered devices not only the memper devices.
Any advice
Thanks in advance
05-29-2007 10:06 AM
Debugging grouping problems can be tricky since it is not very easy to enable debugging. However, you can check the CampusOGSServer.log when you are experiencing a problem with the membership computation to see if there are any associated errors. If not, it may be best to open a TAC service request so that they can guide you through enabling and disabling OGS debugging.
05-29-2007 03:45 PM
Thank you for this update
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: