Cisco SB101 with SNMP

Unanswered Question
May 29th, 2007

Ok, I am very new to routers. I am trying to enable the SNMP through the SDM utility, but there is little information in the screens on to what the best route is for this. I am trying to get the information off the router to a network monitoring utility.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
carenas123 Mon, 06/04/2007 - 08:25

Because SDM uses a default configuration file, if you have used SDM to configure your router, it does not execute the standard Cisco IOS startup sequence.


This Discussion