Help with H.323 setup

Unanswered Question
May 29th, 2007

Hi,

I'm trying to put to work a small voip setup compossed of CCM 5.0 server and a 2821 with a VIC2-2BRI card as TE (user side) and IOS 12.4(10) but its's not working when it comes to call or receive calls from the PSTN/PBX. It seems that the Route Pattern configured in Call Manager doesn't find the gateway and

viceversa. Furthermore I'm not sure whether dial peers are working. Im' using H.323 although previously I tried MGCP also.

When I call from the IP phone no call arrives to the gateway and when I call from the pbx the call does reach the gateway but not the ip phone. The gateway looks unregister in Call manager but i think this is normal in H.323, not sure.

I attach the diagram of my setup. This is the relevan part of my configuration.

Dial-peer voice 1 pots

incoming called-number 6....

direct-inward-dial

dial-peer voice 2 voip

destination-pattern 6...

session target ipv4:10.10.5.1

no digit-strip

dial-peer voice 3 pots

destination-pattern 9...

port 0/0/1

no digit-strip

gateway

int G0/1

ip address 10.10.5.2 255.255.255.0

h323-gateway voip interface

h323-gateway voip bind srcaddr 10.10.5.2

interface BRI0/0/1

no ip address

isdn switch-type basic-net3

isdn protocol-emulate user

isdn layer1-emulate user

isdn incoming-voice voice

Attachment: 
I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion