WIC 2T Problems

Unanswered Question
May 30th, 2007

Dear all ,

Currently i have cisco 1841 router as connected 2 Mbps internet connection in wic 2t serial0 one port.

Last week i bought new 2 Mbps internet line and connected to free wic 2t serial1 port .

But the link was showing down.Again i connected to wic 2t serial0 port,change the configuration, same error continues.

But i installed new wic 2t card ,the new link was working fine.

What is the problem,old wic 2t card is working fine with old 2Mbps connection,new 2 Mbps connection only creating problem.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Wed, 05/30/2007 - 19:55

Hi

Can you post the output of following commands ?

show run / show controller / show diag

do post out the outputs with both the new and old card and with old connection running up and the new connection showing down..

regds

techsertechsupport Fri, 06/01/2007 - 20:55

Hi,

Which make of modem you are using for new 2 mbps link?? & also which make of modem you are using for old 2mbps link?? Please let me know.

Regards,

Prasad

Actions

This Discussion