cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
950
Views
4
Helpful
2
Replies

Monitor qos policy with qpm 4.0 on cisco 3750/3560

pazzoide76
Level 1
Level 1

Hello I have a problem with qpm 4.0.

I have tried to monitor a class based qos policy on a cisco 1800 and I can monitor it but if I tried to monitor same policy on a catalyst 3750 or on a catalyst 3560 i cannot because qpm display that there aren't monitorable policies(see attachment).

I think I cannot monitor qos policies on 3560 and 3750, correct?

Thanks

1 Accepted Solution

Accepted Solutions

Joe Clarke
Cisco Employee
Cisco Employee

Monitoring is only supported on devices that support the CISCO-CLASS-BASED-QOS-MIB and CISCO-CAR-MIB. Unfortunately, the desktop switches (e.g. 3750, 3560) do not use this MIB. They use the CISCO-PORT-QOS-MIB, and thus cannot be monitored.

View solution in original post

2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

Monitoring is only supported on devices that support the CISCO-CLASS-BASED-QOS-MIB and CISCO-CAR-MIB. Unfortunately, the desktop switches (e.g. 3750, 3560) do not use this MIB. They use the CISCO-PORT-QOS-MIB, and thus cannot be monitored.

Thank you for your response.

Cisco is the best

Regards

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco