05-31-2007 03:12 AM - edited 03-05-2019 04:24 PM
Hi all,
I had two routers directly connected via Ethernet
I had configure both as in attached file
I had found that my ibgp neighbour is in active state
any suggestion ?
B#sh ip bgp summary
BGP router identifier 10.10.10.9, local AS number 200
BGP table version is 1, main routing table version 1
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd
2.2.2.22 4 200 0 2 0 0 0 never Active
A#sh ip bgp summary
BGP router identifier 10.10.10.3, local AS number 200
BGP table version is 1, main routing table version 1
Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd
2.2.2.21 4 200 22 22 0 0 0 never Active
05-31-2007 03:36 AM
SOLVED
REGARDS
05-31-2007 03:36 AM
Mahesh,
This link should help:
http://www.cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080093fb8.shtml
HTH,
-amit singh
05-31-2007 04:00 AM
I think you didn't have reachability to the loopbacks
Narayan
05-31-2007 04:53 AM
Thanks dear,
issue was to do clear ip bgp
thanks for a link
Regards!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: