05-31-2007 06:36 AM - edited 03-05-2019 04:24 PM
Hello,
i tryed to configure a etherchannel between a Catalyst 4006 CATOS 7.3 and a 2-stacked 3750 switch. I used 2 GB FX Ports.
I uses LACP with mode actice.
The ports did not build the channel.
Can there be a general problem with this hardware/software combination ?
Thanks
Peter
05-31-2007 07:35 AM
I am not sure catos version 7.3 supported LACP I would verify that first. If not use use PAGP instead .
05-31-2007 07:57 AM
CatOS 7.3 supports Lacp mode for ether-channels. Please see the config guide for the same.
You have to make sure that your port configs on all the ports in an etherchannel has to be same. Configs regarding speed/duplex,STP,trunking feature all have to be exactly same on all the ports.
HTH,Please rate if it does.
-amit singh
05-31-2007 10:36 PM
Hello,
i forgot to mention that i was using cross stack Etherchannel. I think the problem is that the C 4006 is using PSTP and the C3750 is configured with STP.
Can this be the issue ?
Peter
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: