View Tunnel Up

Unanswered Question
ggilbert Thu, 05/31/2007 - 12:15
User Badges:
  • Cisco Employee,

If the peer is connected to your device, you can issue hte command


sh cry isa sa


The above command will show if Phase 1 of the IPSec tunnel is up.


Issue the command given below to find out if Phase 2 is up.


sh cry ipsec sa


Make sure that you have packet encrypts and decrypts are incrementing as they pass traffic.


Hope this explains.


Rate this post, if it helps.


Regards,

Gilbert

Actions

This Discussion