05-31-2007 01:14 PM - edited 03-14-2019 12:54 AM
Hi,,
I installed cisco CRS 4.0(4)_Build140 in my lab envirnment and i would setup an IVR, I had managed to do that.
so i can call IVR from my lab IP Phone and the aa.aef is working fine, but when i tried to call from PSTN the prompt message is fine but when i press 0 for AA i got "the phone no you are trying to reach is currently out of service".
how to solve this issue.
regards
06-01-2007 03:30 AM
Seems like an CSS/Partition issue, did you check that? GW CSS and CTI-Port CSS include your Phone Partition?
06-01-2007 11:36 AM
Thanks for you reply, i'm implementing any partition nor CSS in my lab envirunment, CTI port i'm not sure how to do that. i just wanna basic ivr system.
regards
06-01-2007 11:50 AM
Thanks for you reply, i'm implementing any partition nor CSS in my lab envirunment, CTI port i'm not sure how to do that. i just wanna basic ivr system.
regards
06-01-2007 04:45 PM
What do you mean press 0 for AA?
How is the call flow?
Do you get the menu and then press 0 for operator? If so is the operator parameter (variable) defined as valid DN?
Chris
06-02-2007 01:46 AM
yes i get the menu from my DN (when i call 399 which is my trigger no. in Jtapi subsystem)i also used aa.aef in the script managment and i point the operator parameter to a valid DN.
Now:
When i call 399(my ivr no.) from any DN (ie. 310) i can get the menu and i can call the operator or any DN.
I used the same IVR No. (399) as a connection plar opx in my h323 gateway, i can get the menu but when i press 0 for operator or any DN i got "the phone no you are trying to reach is currently out of service".
regards
06-02-2007 03:58 PM
This does sound like a CSS/Parition issue, so the phones DNs do not have paritions assigned to them, they are assigned to
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide