Unable to make/receive calls Cisco 2801 with Alcatel Adapter 4094

Unanswered Question


I am trying to install a Cisco 2801, with a ISDN BRI connection provided by an Adapter Alcatel 4094.

As far as I know, this Adapter provides an S0 interface.

I am not able either to make or receive calls through this interfeace.

I started with a very basic BRI configuration, and then tried to modify some parameters, but apparently nothing changed (Unknown Number).

The basic interface setup I started using was:

interface BRI0/0/0

no ip address

isdn switch-type basic-net3

isdn incoming-voice voice

With the same configuration and equipment I was able to both make and receive calls in my lab, with a regular ISDN BRI connection.

Any ideas?

Thanks in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Fri, 06/01/2007 - 06:15
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member


Please post complete output of "debug isdn q931". Perhaps there is something the adapter doesn't like.

Does the adapter have configuration options like, which numbers has to answer, etc ?


This Discussion