Hi,
I am trying to install a Cisco 2801, with a ISDN BRI connection provided by an Adapter Alcatel 4094.
As far as I know, this Adapter provides an S0 interface.
I am not able either to make or receive calls through this interfeace.
I started with a very basic BRI configuration, and then tried to modify some parameters, but apparently nothing changed (Unknown Number).
The basic interface setup I started using was:
interface BRI0/0/0
no ip address
isdn switch-type basic-net3
isdn incoming-voice voice
With the same configuration and equipment I was able to both make and receive calls in my lab, with a regular ISDN BRI connection.
Any ideas?
Thanks in advance.