06-01-2007 02:14 AM - edited 03-05-2019 04:26 PM
I am using a CISCO 3550 Multilayer switch with the
IOS version 12.1(11)EA1. I am configuring
Virutal link with the following commands :
**********************************************
cisc0(config)#router ospf 10
cisco(config-router)# area 1.1.1.1 virtual-link 8.8.8.8 authentication null dead-interval 40 hello-interval 10 retransmitt-interval 5 transmit-delay 2
cisco0(config)#
********************************************
But the DUT does not make 8.8.8.8 as its neighbour. The area 1.1.1.1 is a transit area.
Kindly let me know whether any other configuration is required
06-08-2007 06:55 AM
A VLAN interface created by using the interface vlan vlan_id global configuration command and by default a Layer 3 interface.
06-08-2007 11:20 AM
Can you post a brief n/w topology?
What do you see when you do a debug ip ospf adj?
Narayan
06-08-2007 12:00 PM
is 8.8.8.8 the router-id ? that portion of the command needs to be the router-id, not necessarily the IP address.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: