are AP1242 in workgpbridge mode roaming capable ?

Unanswered Question
Jun 1st, 2007
User Badges:

hi all ,

i have aps 1242 with wireless client associated and an ap1242 in workgroup bridge mode associated too , can the ap in workgrp mode roam between different AP1242 ? if yes is there some special conf needed ?

normaly the client decide wich ap to associate with , does ap in workgrp have the same capacity ?

some sample or link will be very helpfull

thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Rob Huffman Fri, 06/01/2007 - 06:20
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Alain,


Try this out;


Q. How do I configure my AP acting as WGB to dynamically switch between parent access points based on signal reception?


A. Use this command in order to configure the Workgroup Bridge as a mobile station:


ap(config)#mobile station


When you enable this setting, the Workgroup Bridge scans for a new parent association when it encounters a poor Received Signal Strength Indicator (RSSI), excessive radio interference, or a high frame-loss percentage. With the use of these criteria, a Workgroup Bridge configured as a mobile station searches for a new parent association and roams to a new parent before it loses its current association. When the mobile station setting is disabled, the default setting, the Workgroup Bridge does not search for a new association until it loses its current association.


From this good doc;


http://www.cisco.com/en/US/docs/wireless/access_point/12.3_7_JA/configuration/guide/s37hot.html#wp1041626


Hope this helps!

Rob

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode