Upgrade IPCC Enterprise from 7.0 to 7.1(4)

Unanswered Question
Jun 1st, 2007


I had problems when i tryied to upgrade IPCC Ent. from 7.0 to 7.1(4).

I received message that the database can not be updated.

The error in logs was:

2007-05-08 19:16:50 [Information] Running command: C:\icm\bin\upgrade.exe -d fibcc_sideA -dt logger -i fibcc -dr reset

2007-05-08 19:16:51 [Error] C:\icm\bin\upgrade.exe failed with error 0x1 (1): Incorrect function.

2007-05-08 19:16:51 [Error] An error occurred while udpating the the schema for the database fibcc_sideA.

Logs of the database operation can be found in C:\Temp\<hostname>_fibcc_sideA.log

Does anyone have the same problem and is there some decision for that problem?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Chuck Smith Sun, 06/03/2007 - 06:17

Read the release notes. Most probably you will have to upgrade to 7.1(2) before goign to 7.1(4)

ayordanov77 Mon, 06/04/2007 - 00:29

Thanks for the tip.

I have the thoughts in my mind, but i was not sure about it.

I will make a test on the test IPCC that i installed and i hope that it will works.

When i finish the test i will post the result.


kent.roberts Tue, 06/05/2007 - 18:50

When I updaed 7.x I installed 712 first, then went to 714. Don't forget to update ctios and cad (if you use them) The must be run with the proper version. FYI the backout/removal of 712 to make the system back to 7.0 failed.


This Discussion