06-01-2007 07:04 AM - edited 03-13-2019 04:11 PM
I have a question that I'm having difficulty finding an answer for. Is it possible to run both MGCP and H323 on the same router simultaneously? I have a customer that needs H323 on one or two FXS ports but has only MGCP gateways. They would like to avoid buying more hardware.
Thanks.
06-01-2007 07:08 AM
Yes this can work fine. You can run both MGCP and H323 on the same router. MGCP would only control the FXS port where there is a dial-peer with service mgcpapp configured. So if you want to use the FSX ports as H323 then all you need to do is configure these ports the way you would configure any FSX port for H323.
I hope this helps.
06-01-2007 07:11 AM
Great. Thanks. This was my gut feeling, but this gateway serves a large number of other circuits and I did not want to take the whole gateway down if I was wrong.
06-01-2007 07:22 AM
as long as you change the config of only the FXS ports in question, it should not affect any other interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: